Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

This article will help guide you through the process of setting up the VPN client on your personal computer.

Installing the software

It is only a few steps to configure the connection. First, download and install the client.

  1. Please go to the following link: https://www.checkpoint.com/products/remote-access-vpn/

  2. Click View Downloads

  3. Select the Windows version

  4. Download and run the installer

    1. Click Next until presented with the option for Endpoint Security VPN, select it and click Next again

    2. Accept the License Agreement, click Next

    3. Click Install

Setting up the connection

Once installed, the client will start in a minimized state down by the clock.

  1. Double click the yellow lock icon and proceed through the setup wizard when prompted

  2. Click Next until prompted for the Server address or Name, enter vpn.felician.edu

  3. Click Finish once the process completes

Connecting to the VPN

With the site successfully added the next step is to connect to the VPN.

  1. Right click on the VPN icon in the bottom right and click Connect

  2. Enter your Felician Username (your full email address) and Password, then click Connect

  3. Once connected successfully, the icon will change to green, and if you have sound enabled, will hear a little tweet / chirp noise.

Once you have finished with your work, remember to disconnect from the VPN client by right clicking the icon from Step 1 and disconnecting.

  • No labels